Integral C-01 electronic stopwatch

The electronic stopwatch "Integral S-01" is an electronic device with an autonomous power supply and a liquid crystal display (LCD). The principle of operation of the electronic stopwatch is based on the use of a quartz oscillator and microprocessor, which provides operation of the device in all modes and outputs the measurement information to the LCD display.

 

Electronic stopwatches "Integral S-01" are designed for use in scientific and industrial activities, sports and other areas that require accurate measurement of time intervals.

 

The device provides operation in two modes - "stopwatch" and "watch". Mode selection and control in each mode is carried out by the corresponding buttons. In the "stopwatch" mode the measurements of time intervals are carried out, it is possible to enter the results of measurements into the memory (maximum number of measurements - 10), read and erase the results of measurements. The "clock" mode displays the current time on a twenty-four-hour scale in hours, minutes and seconds.

 

 

 

 

 

      Electronic stopwatches "INTEGRAL S-01" are measuring instruments and are subject to primary calibration in the accredited laboratory of the metrology department of "INTEGRAL" - the managing company of "INTEGRAL" Holding (Accreditation Certificate BY/112 3.0276). Verification interval - 1 year. Information about verification is reflected in the product passport, certificate of verification, as well as on the verification mark (sticker) on the back cover of the device.

 

 

 

      Electronic stopwatches "Integral S-01" are registered in the State Registers of Measuring Instruments:

 

Republic of Belarus (registration number RB 03 15 1655 20);

Russian Federation (registration number 44154-20);

Republic of Kazakhstan (registration number KZ.02.03.00478-2020/RB 03 15 1655 20).

 

 

Main characteristics:

 

Name of characteristic, unit Value

Measuring range of time intervals, s from 0 to 9 h 59 min 59,99 s

Discreteness of the measured time intervals, s 0,01

Maximum permissible basic absolute error of measurement in stopwatch mode at standard measuring conditions (25 ± 5) °С, s

where Тх is the value of measured time interval, s ± (9,6 - 10-6 - Тх + 0,01)

Admissible additional absolute error of measurement in stopwatch mode, caused by the ambient air temperature deviation from normal conditions (25 ± 5) °С in the interval of working temperatures from minus 10 °С to 50 °С per 1 °С of temperature change, s -2,2 - 10-6 - Тх

Daily rate of change of clocks at a temperature of (25 ± 5) °С, s/day ± 1.0

Daily rate of the clock at a temperature of (23 ± 2) °С, s/d ± 0.5

Daily rate of the watch within the temperature range from 1 °С to 45 °С, excluding the temperature range (25 ± 5) °С, s/day ± 2,5

Daily rate recovery, s/day ± 0.5

Estimation number, max 1.6

Consumption current at supply voltage 1,5 V, μA max 4,0

Overall dimensions, mm, not more than 77 × 58 × 22

Mass, kg, not more than 0,05

Working conditions in stopwatch mode:

- ambient temperature, °С

Service conditions in clock mode:

- ambient temperature, °С

minus 10 to 50

1 to 45

 

Transport conditions:

- ambient temperature,°С

- relative humidity

 

from minus 10 to 50

not less than 98% at 35 °С

 

 

 

In electronic stopwatches "Integral S-01" there is a possibility of control by external electric circuits. The START/STOP and RESET buttons as well as the "+E" power supply are connected to the connector located under the manhole cover in the rear cover of the device. The connector on the stopwatch board is a PLS2-3 plug. The product includes a BLS2-3 socket connector.

 

 

 

 

 

Connector connection diagram:

 

 

 

      The delivery set:

- Electronic stopwatch "Integral S-01" - 1 pc;

- Power supply element type L1142 or analogous (as a part of product) - 1 pc;

- The passport - 1 pc;

- BLS2-3 socket-outlet for connecting external electric control circuits - 1 pc;

- Verification certificate - 1 pc;

- Individual package - 1 pc;

- Verification procedure of MF. МН 1177-2002 (supplied at customer's request)