AE aquadistillers (Livam, Russia)

Distiller AE-15 is designed to produce high-quality distilled water, corresponding to FS 42-2620-97 "Water for injections", FS 42-2619-97 "purified water" and GOST 6709-72 "Distilled water. it is recommended for medical, technical and domestic use. Can be connected to the collection of purified water storage.Use aqua-distiller medical AE-15 can be in any, even the most remote areas, as for work you need only electricity and water.

 

The advantage of the AE-15 is a unique quick-disassembly design, greatly facilitating the process of cleaning and maintenance. The electric aqua-distiller AE-15 is ideal for laboratories and medical facilities, with a flow rate of distilled water up to 15 liters per hour. The distillation unit allows 3 types of water to be obtained without the use of expensive filters, resins and special membranes.

 

The distillator is equipped with a special heat shield, which provides an optimal surface temperature of the aqua-distillator during its operation and protects the personnel from heat burns.

 

The automatics system of the distillator provides automatic switch-off of electric heating, if the water in the evaporation chamber decreases below the permissible temperature.

 

The AE-15 laboratory distillation unit has the ability to connect with a tank - a collector for storing purified water in a single system, with automatic shutdown of the aqua-distillation unit after the filling of the collector. It is possible to connect the water entering the distillator by a two-circuit scheme, to reduce the consumption of raw water by 70-80%.

 

Features:

 

The assemblies and parts in contact with steam and distilled water are made of stainless steel 12X18H10T and other materials that do not affect the quality of the produced water.

Low power and water consumption.

Automatic maintenance of the amount of water in the aquadistillator, going to evaporation.

Produces distillate at temperatures between 25 °c and 40 °c by means of a distillate cooler. Distillate cooler to be purchased separately.

Source water and distillate drainage tubes are included.

Automatic disconnection of electric heaters, when water flow has stopped and the water level in the evaporation chamber has dropped below the permissible level.

The possibility of mounting the aqua-distillator on the wall. Bracket can be purchased separately.

The possibility of separate water supply for cooling and evaporation from two different sources. Water entering the evaporation chamber must have an electrical conductivity greater than 2 μS/cm. Otherwise, the water may fail to turn on the water heating.